Sheet metal laser cutting processing error caused by the size of the reasons


Sheet metal laser cutting error in size is often encoun […]

Sheet metal laser cutting error in size is often encountered in the use of laser cutting machine processing failure, this failure not only affects the production efficiency, but also increased production costs. Caused by processing errors in the size of the main reasons are as follows:
1. The signal line is not normal. In this case, you need to replace the signal cable.
2. The equipment and computer are not grounded properly. At this point you need a good grounding of the device and the computer.
3. The computer is not working properly. At this time need to repair the computer or replace the computer.
Computer operating system failure or infection with the virus. Need to reinstall the operating system or virus killing.
5. application software is not normal. Then need to re-install the software and motion control card driver software.
6. The power supply is unstable or by the interference signal. At this point need to install a voltage regulator or remove the interference signal.
7. Processing program is not prepared correctly. At this point need to check and repair processing procedures.
8. Processing parameters set incorrectly. To reset the correct processing parameters.